Kolcraft Cloud Sport Assembly – Instructions

Kolcraft Cloud Sport Assembly – Instructions


Thank you for purchasing the Kolcraft
Cloud Sport lightweight stroller. Before using the stroller, be sure to read
through the instruction manual. Today, we are going to show you how to assemble
your new stroller. Here are all the parts that are included: Stroller frame with basket, Rear brake assembly, Parent tray, Child tray, Front wheel assembly, 2 rear
wheels, Headrest, 2 washers, 2 cotter pins, 2 hub caps, and Rear basket tube. Remove all of the stroller parts from the box. Remove and discard any protective inserts or foam pieces. Insert the rear basket tube into the exposed
basket frame behind the stroller seat until the spring buttons lock into place.
Attach the storage basket around the rear basket tube using the snaps. Release
the locking latch on the stroller frame and unfold the stroller frame until it
clicks into the open position. Turn the stroller over. Move the footrest
up to expose the front stroller cross tube. Wrap the front of the storage
basket around the front cross tube and secure with snaps. To attach the rear
brake assembly, remove and discard the protective caps on the bottom of the
stroller frame. insert the rear wheel assembly onto the rear of stroller tubes with the brake pedals facing outward. To attach the rear wheels, slide a rear
wheel onto the axle followed by the washer. Fit the straight part of the
cotter pin through the hole in the axle. Line up the tabs on the hub cap with the
holes on the wheel and snap into place. Repeat for the other rear wheel. To attach the front wheels turn over the front wheel assembly so the tab is visible to you Push the front wheel assembly on to the front roller frame until it clicks into place. Repeat for the other wheel. Pull in the front wheels
to ensure they are securely attached. Turn the stroller upright. Push the
footrest down to its lowest point. To attach the child tray, align it with
the notches on stroller frame. Guide the tray on to the frame until the button
snaps into place. To attach the parent tray, align the holes on the tray with
the posts on the stroller handle and snap on one side then the other. Your stroller is ready to use! We hope this video helped you put your
Kolcraft Cloud Sport together. Look for a separate video on how to use your new
stroller. If you have any questions or need further assistance, contact us at
1(800) 453-7673, or visit Kolcraft.com

1 thought on “Kolcraft Cloud Sport Assembly – Instructions”

Leave a Reply

Your email address will not be published. Required fields are marked *